Converting Flip 3d to electric

[cebola]

I was thinking in buy the Kiosho Flip 3D and convert it to electric.

In fact I will gonna use the Hyperion Z3025 10 and a batterie 4S 4.000mA, turning a 12X6 apc prop.

This give's me a static trust of 100oz

I would like your suggestions


Cebola
Brazil

[Mike Parsons]

I was thinking in buy the Kiosho Flip 3D and convert it to electric.

In fact I will gonna use the Hyperion Z3025 10 and a batterie 4S 4.000mA, turning a 12X6 apc prop.

This give's me a static trust of 100oz

I would like your suggestions


Cebola
Brazil
Cebola,
I havent done near as much research on the Hyperion motors as I should have done by now. I assume this is going to be the Flip 40? The Flip 25 is one that I have admired for a while however I could never get them here in the states. I would like to see how your setup does.

Cheers,
Mike

[cebola]

I would like to see how your setup does.

Cheers,
Mike

Hello Mike

The Hyperion 3025 10 is too mutch for the Flip 3D 40, the model climb's vertically, in 2/3 of full engine.
Fully aerobatic, and very light 50oz total wheight.
One big problem is the batterie, I use a E Model 4S 4A, and it blows like a baloon, this engine uses 50A in burst, and the batterie did not support 12C (and cost a lots of money:( ).
But the models is OK and I gonna make a new try, using a Hyperion Batterie in 6S and 4A.
I love the way the model behavies, mainly in 3D maneuvres.

Just fantastic!

Cebola Brazil