PDA

View Full Version : Panic Attack

Unbalanced prop
10-01-2005, 09:07 PM
Just finished up a Panic from mountainmodels. Typical MM quality and easy assembly. Hope to maiden tomorrow. I am using a Hyperion 2213-24 with a 10x4.7 APC SF to start with. Here are some figures from my Emeter.

Volts=10.65 amps=15.0 watts=160 rpm=6300

AUW with a 3S TP1320 is 17.1 ozs. Should have plenty of power.:D

Doug
NitroCharged
10-02-2005, 01:04 AM
Nice finish Doug.

Good luck on the maiden! :)
pace_likethesalsa
10-02-2005, 06:15 AM
i like, it looks nice. Have fun!
buzzltyr
10-02-2005, 02:18 PM
My Panic. The only foamie I own!

Mark
Unbalanced prop
10-03-2005, 04:38 PM
Maiden was a success!!:D Got five flights in, two with a 10 x 4.7 and three with a 11 x 4.7 APC SF. The larger prop really brought this plane to life. With the larger prop I was pulling around 18.5 amps and 200 watts at WOT. But except for full throttle pull outs, I fly around at half throttle. Landed after 15 minutes each flight still with plenty of power. Motor and battery only luke warm. I am using TP 3S 1320 packs and put about 1000 mah back in them.

If I could just fly better!! It rolls quickly, hovers as good a I can do it at half throttle, flys inverted easily and even I got a knife edge for about five seconds. The plane almost makes it look like I know what I'm doing.:cool:

Doug
NitroCharged
10-04-2005, 04:36 AM
sweet! :)
glenclif
10-11-2005, 08:02 PM
Mark,

How do you tell right side up on your Panic?
buzzltyr
10-11-2005, 10:05 PM
Mark,

How do you tell right side up on your Panic?

Hi Glenn,
The bottom is all red. Both shots are of the top.

Mark
glenclif
10-12-2005, 02:38 PM
Duuuuuhhhhhhh.......:rolleyes: I'm usually not that dumb.