PDA

View Full Version : CC Phoenix 25 programing


KenS
10-09-2005, 12:04 PM
I am using a Hacker 20/22L with a TP 3s1320PL and a 9x5 GWSDD prop ona ZoomZoom 4d.
Here are my settings, I am totaly new to programing these ESC..
Ok I have set it up this way let me know if I should change:
CutOff Voltage 9.0
CutOff type: HARD
Brake: No Delay Hard
Throttle: Auto Calibrating
Start: Soft Start

fdix
10-09-2005, 12:32 PM
I would change the cut off type. Change it to soft, this because with hard cutoff the esc simply cuts power instantly, this is not nice if you are in hover a few feet above ground.
Soft cutoff gradually reduces power so you have all the time to get out of any risky manouver and land.

Hotshot Charlie
10-09-2005, 01:29 PM
I agree with fdix, all else looks fine. Have fun !

hoppy
10-09-2005, 01:43 PM
I prefer "No Brake", "Soft Cutoff".

KenS
10-09-2005, 02:00 PM
Thx, I will change to No Brake

I just unwrapped my engine, it has male bullet connectors factory installed, and me with no female plug ends arghhh no flying today. http://www.rcgroups.com/forums/images/smilies/smiley35.gif
Not sure what size they are so I emailed Hacker asking them.

qban_flyer
10-09-2005, 03:15 PM
Thx, I will change to No Brake

I just unwrapped my engine, it has male bullet connectors factory installed, and me with no female plug ends arghhh no flying today. http://www.rcgroups.com/forums/images/smilies/smiley35.gif
Not sure what size they are so I emailed Hacker asking them.

More likely than not they are 3.5mm female bullet connectors. That's the regular fare for up to 35 amps, though perhaps in the spec sheet you may find the exact type specified by the motor manufacturer.

I agree with the No Brake and Soft Cutoff as suggested above. Worse thing that can happen to us while 3diing is to be hovering three feet off the ground and have the motor cutt off. Been there, done that. Once was enough for me.