PDA

View Full Version : Balance connector


Joe Lang
10-29-2005, 12:03 PM
I recently purchased a 3S 1800 mAh Electric Power lipo battery from xushobby that has a four wire female connector for checking and balancing the voltage for the individual cells in the pack. It looks like an internal computer board connector. I need a male connector, actually several I guess, with the correct spacing for charging/checking each individual cell. Does anybody have a source for these plugs? I guess I could fashion one on a block with some pins with the correct spacing if the plugs are not readily available.
Joe Lang

Joe Lang
10-30-2005, 11:00 AM
I recently purchased a 3S 1800 mAh Electric Power lipo battery from xushobby that has a four wire female connector for checking and balancing the voltage for the individual cells in the pack. It looks like an internal computer board connector. I need a male connector, actually several I guess, with the correct spacing for charging/checking each individual cell. Does anybody have a source for these plugs? I guess I could fashion one on a block with some pins with the correct spacing if the plugs are not readily available.
Joe Lang

Is anybody using the batteries with the balancing connectors? What are you using for the charging (male) lead?
Joe Lang

giflyrc
10-30-2005, 02:34 PM
Look here Joe at the Polyquest connectors about half way down the page

http://www.aircraft-world.com/shopdisplayproducts.asp?id=33&cat=battery+%2D+WIRE+and+CONNECTORS

Others on page too

Roger aka GIFLYRC

Joe Lang
10-30-2005, 03:34 PM
Look here Joe at the Polyquest connectors about half way down the page

http://www.aircraft-world.com/shopdisplayproducts.asp?id=33&cat=battery+%2D+WIRE+and+CONNECTORS

Others on page too

Roger aka GIFLYRC

Hi Roger, The Polyquest connectors are exactly what I need. Thank you for the link to the site.

Joe Lang

giflyrc
10-30-2005, 06:20 PM
Glad I could help!

Roger

Durwood
08-03-2007, 01:55 PM
I found a connector at an electronics outlet that fits the balance connector on the batteries that XUS sells. The web site is www.allelectronics.com (http://www.allelectronics.com). The part number for the connector is Con-244 and it comes with a header that can be soldered to and make a male counterpart if desired. They sell for $1.30 each and have about 10 inch leads. In fact, I have used these to adapt all my batteries to the same connector, just a matter of cutting off the old connector and soldering the new connector on with heat shrink tubing to insulate it. Hope this helps..:):):)

Durwood