PDA

View Full Version : See-saw setup help needed


HeliG
03-19-2008, 05:56 AM
Hey all,
I have a quick question that I could not find an answer to. While following Finless' CCPM 2 vid, I am stuck between the swash and see-saw. I would assume that the rods should be the same length but to get the see-saw level on both sides, they will be different lengths. Can you please advise?

This is for my T-rex 450 SE V2.

theecoop
03-19-2008, 01:48 PM
HeliG,

I believe the reason your getting different lenths is because the servo arm teeth . When I first put mine together and had it inspected by a pro..
I found that the arms to get you 90 degrees at center stick was one notch off. so I had to replace thar arm since one usually cuts off the extra. ....But imo as long as your getting 90 degrees at 0 stick and getting full travel, you should be ok.