PDA

View Full Version : Nichrome wire foam cutting


cncfoam
03-25-2008, 04:33 PM
Everyone,
I had to buy a full roll of nichrome wire.
I have a ton extra that I would like to get rid of.
Brand New "ULTIMATE" HIGH STRENGTH WIRE Gauge 30 AWG 0.010" dia
Gateway's "Ultimate" wire is the strongest material available in the temperature range of 1200 to 1800 degrees Fahrenheit. The wire is rene based alloy which has a higher tensile strength than inconel 750 wire. Because of these characteristics, you will find that "Ultimate" wire will give you significantly less wire breakage, reducing down time, and scrap as a result of wire breakage.
This is the wire that is used by commercial foam cutters, it is sold by Gateway Precision Technologies, a manufacturer of high quality commercial foam cutters. Gateway only sells this by the full roll. I don't need a full roll so I am selling off some of the extra.
I use this wire for cutting EPP foam wings. It works great, Low Heat, no burn on the tips, high strenth, small kerf, smooth cuts. I'm not sure what the actual composition of the wire is, but, what I do know is that it works awesome.
I will sell off any length you want at .13 cent per foot. $4.95 shipping USA
thanks
Eric

cncfoam
04-23-2008, 03:13 AM
ALL gone.
thanks
Eric