Blade Cx problems

[jmortyman]

I purchased my blade cx last week. It flew good and was getting used to it. An unfortunate crash and I had to replace the inner shaft. While I was at it I installed a heatsink on the advice of a friend. Now when I lift it off, it will go in a fairly wide circle with no inputs from the controller. It will pull to right,aftthe left forward. I'm brand new to this and would appreciate any help I can get

[rmbler]

Check to see if the inner shaft is tightened properly , as well as the gears,(Make sure the two screws on the gear are tightened and the gears are seated properly, The bottom of the shaft should be flush with the gear. Check that the fly bar is moving freely when I changed my inner shaft I had the two nubs off just a little from the holes on the hub. If All this is good i would look into one of the motors.
Hope This Helps,
Regards,
Phil.

[jmortyman]

The flybar was binding quite, got it loosened up and works ok now, thanks for the help,
Morty