PDA

View Full Version : Replacements for 3536 1100kv


tarheal63
10-04-2010, 07:16 PM
Does anyone know where I can find a new prop shaft for my Turnigy 3536 1100kv motor? It is listed at HobbyKing (http://hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=5497) but apparently it has been on backorder for some time. I nosed my Spit in and bent the shaft, the motor spins perfectly but it is kind of hard to fly with no prop, any suggestions welcome. I didn't know if some of the other spare for the other motors would work or not. It is a 4 mm shaft.

constantCrash
10-04-2010, 08:07 PM
any 4mm shaft should work as long as it's long enough. say, the replacement shaft for a Parkzone 480.

newjak
10-04-2010, 08:25 PM
Does anyone know where I can find a new prop shaft for my Turnigy 3536 1100kv motor? It is listed at HobbyKing (http://hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=5497) but apparently it has been on backorder for some time. I nosed my Spit in and bent the shaft, the motor spins perfectly but it is kind of hard to fly with no prop, any suggestions welcome. I didn't know if some of the other spare for the other motors would work or not. It is a 4 mm shaft.

If this is your motor http://www.hobbycity.com/hobbycity/store/uh_viewItem.asp?idProduct=3886 than this shaft should fit it http://www.hobbycity.com/hobbycity/store/uh_viewItem.asp?idProduct=6488 The link in you post is for the prop adapter. Is that the part you are looking for?

tarheal63
10-04-2010, 11:31 PM
Actually, this is the piece i am looking for, it bolts on to the end of the motor and there is a threaded shaft underneath the cone.

newjak
10-04-2010, 11:53 PM
Take a look at this one. http://www.headsuprc.com/servlet/the-1439/Rotor-End-Prop-Adapter/Detail
I have both Turnigy motors and headups RC motors with 35mm diameter and that part is interchangable.

tarheal63
10-05-2010, 04:49 AM
That looks to be it, thanks much.