PDA

View Full Version : brushless in runner shaft swap


Rhino_Aus
10-13-2014, 12:35 AM
Hello all!

I recently purchased several different 12mm sized inrunners from HobbyKing (turnigy 1220, 1230, and BL1230) which have 2.00mm shafts that taper to 1.48mm where you would attach a prop or gear to. I need a 2mm shaft the entire length but don't know how to open these motors as there is no obvious way to take them apart. Does anyone have any experience or advice?

NoResults
10-13-2014, 10:37 PM
On Turnigy motors that I have had to reverse shafts you just remove the keeper ring and collette and hammer it out or put in a vice and press.

Rhino_Aus
10-13-2014, 11:20 PM
That's the bit on not sure on. What are and how do I remove the keeper ring and collette?

flydiver
10-14-2014, 02:30 AM
INRUNNER > the shaft is generally fused/glued/permanently-attached to the rotating magnets. Chances are you are out of luck for shaft replacement.

Here's how you open them:
Motor Shaft Replacement (http://www.maxxprod.com/mpi/tips2.html)

Best bet is something like Chellie is suggesting below.

CHELLIE
10-14-2014, 10:34 AM
1.48 mm _ 1.5 mm same thing, prop adapters, Hope this helps, Chellie

http://www.ebay.com/itm/NEW-Great-Planes-Collet-Cone-Adapter-1-5mm-3mm-Prop-Shaft-GPMQ4982-NIB-/331342362609?pt=Radio_Control_Parts_Accessories&hash=item4d258b37f1

http://www.ebay.com/itm/EFLM1933-Prop-Adapter-With-Setscrew-1-5mm-/271634937917?pt=Radio_Control_Parts_Accessories&hash=item3f3eb4383d

http://www.ebay.com/itm/NEW-Great-Planes-Collet-Prop-Adapter-1-5mm-3mm-Prop-Shaft-GPMQ4950-NIB-/390885896041?pt=Radio_Control_Parts_Accessories&hash=item5b029d6f69

http://www.micronwings.com/Products/SectionPropAdapters/

http://www.hobbyking.com/hobbyking/store/__34160__durafly_micro_series_replacement_propelle r_adapter_us_warehouse_.html
the hole is 1.5mm that will squeeze down onto a 1.48 mm shaft

http://www.micronwings.com/Products/PropSaverAlloy1.5mm/index.shtml

Durafly™ Micro Series - Replacement Propeller Adapter (US Warehouse) ... 8/9/2014. any with a 1.5mm prop shaft This fits the AP05-3000kv brushless motor.