cbatters

Hey Clint,

Allow me to revise my request: I have two non-functioning AB3 rx's, both with busted crystals. ( one channel 4, the other 6) I havent tested them with good crystals, but i dont think thats the only problem because i can see some of the SMD components have been knocked off. I would like to send them to you and buy two working rx's, if you have some for sale, as well as a spare crystal for each.

Is that possible?

thanks,
Jordan

FET often fails shorted, often from failed blocking diode.

Remove FET and check diode to make sure it is OK before replacng FET.

Paypal funds to cbatters@lancache.com and I will get the crystals in ~8-10 days.

im looking to purchase 2 each of channel 4 and 6.

I also have a malfunctioning AB3 rx that is constantly supplying power to the motor, any hints on how i can fix that?

sorry about the vm, not enough posts for a pm, dont have the time to fluff some right now

Hey Clint,
I would like to buy some AB3 crystals, but you dont have space for a pm

Hello Clint,

I seem to be having the exact same problem with the T-28 as it glitches while flying. It rolls uncommanded. I have tried numerous fields with the same problem so it is not interference.

I think it could be the battery connection as the only time the ailerons glitch in ground testing is when the battery is unplugged and plugged back in.

Let me know what you have found out in yours.

Cam

Hi - I saw your post on the Radian thread that you had put a 3s 1000 Mah LiPo in your AB3 and I was curious if you added any ballast, and if you had changed the electronics at all to take the extra voltage? I have an AB3 as well, and I'm thinking to try this but don't want to fry the board :-)

Thanks in advance for any info

Fred

I started a new forum if you would like to stop by. Pass the news around if you like.

Thanks,
Travis
"CLSSY56"
http://www.HorizonRcFlyers.com

Did you recieve the electronics?

Hi, Ive just purchased a HONEY BEE CP2 (crash repair) with twin motors. Ive gone throuhgh the normal checks and things seem ok. This helicoper still spins clockwise although the mixer and trims have been adjusted to thier maximum. Is there any other ajustments I can do ? (are twin motors more powerful)