Rx red blinking light
Airplane is a cheap 3ch arf J3 from Hobby King Using recommended 380 brushed motor,18amp brushed esc,2s 20c 7.4 volt 1,000 Mah lipo batt (recommended batt is 7 cell 8.4 volt ni-cad) OrangeRx R615 6 ch 2.4 reciever While testing set up to see how long batt power will last after about 10 min at approx 60-65% motor is a little warm but not hot and power seems to still be pretty strong,but a red light in Rx starts blinking ( this is independent of the solid orange light)At this point I shut the system down.Does this blinking red light indicate a problem?
Flashing red light indicates that there has been brief losses of signal, the more flashes the more signal loss.
It's explained in the manual: http://www.hobbyking.com/hobbyking/s...X530707X30.doc
It could be due to interference if you are testing indoors. Take it outside and see if there s still an issue. Also do a range check.
Testing was being done indoors.After being off for aprox 2-3 min powered it back up to 50% for 15 min still running strong no blinking(no recharge)
|All times are GMT +1. The time now is 01:23 AM.|
Powered by: vBulletin
Copyright ©2000 - 2013, Jelsoft Enterprises Ltd.
Copyright 2005 WattfFlyer.com
RCU Eflight HQ