Hi Larry, I've been going over your drawings and they seem pretty clear. It sure would be great however to have some close up pictures of a finished model and particularly the control linkages as you suggest. It took me a while to figure out that the electronics can be 'hidden' in the space between the center fold and the center brace and that you make some kind of hatch once the CG is determined. Do you seal this compartment at the front to the keep the water out (I'm thinking mostly about protecting the battery as the receiver and ESC will be waterproofed) or leave it open for air flow?
My depron is somewhere en route from Atlanta. I'm tempted to just try foam poster board as a prototype to start with but then I'll probably want to try and make that fly so I better wait :-)
Cheers,
Rick
|