Originally Posted by evlwevl
The antenna was placed on the sidewall inside the fuse with nothing around it. All the wires from the rudder and elevator servos run under a separate foam channel to the front of the plane. This was basic foam/ light ply construction with only 2 small carbon rods on the outsides of the wings for support. I'm thinking I might end up holding onto my FM radio and recievers in my full range gliders, cause this one has got me spooked.
Hi
its possible that your battery was low, and a sudden burst of power, WOT could have caused a low BEC voltage issue, and caused a brown out, if thats the case, a UBEC would have prevented that, just my 2 cents worth
Keep your 72mhz as a back up, if your 2.4 Transmitter takes a Dump
and try Berg Receivers on 72Mhz , They are the best of the Best, they are made by Castle Creation, I like the Berg 4L receiver on my park fliers, only use Berg Crystals, on all 72Mhz micro receivers, use scotch tape to hold the crystal in, because they have very small pins, and can vibrate out, Take care and Have fun, Chellie
http://www.thefind.com/instruments/b...berg-receivers