Hi,
The ESC and Prop should be a good match for that motor. Probably won't draw near the max amps, so that is good, and your ESC is well rated for more current.
As far as the motor, I do not know much about that particular motor and have not test fit it with my mount or on the plane.
Couple things to double check. The aluminum mount I sell is designed to attach to a motor bolt pattern that is 16mm x 19mm meaning two holes will be 16mm across and the other two holes will be 19mm across from each other.
The motor diameter should be 28mm (max diameter of the can), and the overall length of the motor (from bolt holes in the rear to the front of the motor not including the shaft) should be 34mm or less. If your motor happens to be a bit longer, that would be OK, but you may need to enlarge the opening on the front of your cowl. I would say the most important thing is the 16x19mm bolt pattern and the outside diameter of the motor.
If your motor meets these specs, then it should fit nicely. If you have the motor with you and want to take some measurements I can double check for you as well.
Thanks,
Terry
|