Originally Posted by nwillitts
trying to measure motor mounts now-all other specs are in line.
not sure how to convert inches to mm.
gonna order motor you suggested just in case.
thanks for your help.
To convert inches to mm simply take the inches and multiply it by 25.4.
To go from mm to inches, take the mm value and divide it by 25.4.
You're motor should be really close if not a perfect fit. I did see that it is a 28mm diameter on their website. Just not sure what the bolt pattern is.
If you measured in inches from center of hole to center of hole, it should be (16mm) .630" (or just over 5/8") and the longer dimension would be (19mm) .748" (or 3/4"). Your measurement does not need to be exact either.
You will most likely have a 16x16mm, 16x19, or 19x19mm bolt pattern. But most common I have seen on these 450 motors is 16x19mm.
Also, since you have upgraded your ESC as well, you could go with the Power Up 450 Speed which will give you higher KV and more speed.
Hope this helps.
Terry