View Single Post
Old 07-06-2011, 04:05 PM   #4
Rodneh
Member
 
Join Date: Oct 2005
Location: Florida, USA
Posts: 718
Thanked 69 Times in 68 Posts
Club: Moonport Modelers
iTrader: (0)
Friends: (0)
Default

When you have any loads such as servos that draw high current, the safest way is to separate servo power from receiver power. Just use any small capacity battery (the current drain is very low) to power only the receiver and then power the servos with a separate bus. Now, even if you get a momentary voltage drop on the servo bus, the receiver keeps on chirping happily along and you will never suffer a brown out.
Rodneh is offline  
  Reply With Quote
 
Page generated in 0.08361 seconds with 17 queries