I am setting one up myself using a hacker motor with a 12x6 I am going to try a 11.5 first.
http://www.aero-model.com/Hacker-Bru...30-16M-V2.aspx
For rudder and stab 2 hitec 82 mg servos, for the ailerons I am using 2 9g mg servos from Heads up. Batteries are the gens ace 3c 20A 2200mah battery from HobbyPartz I have a few of these all ready.
I have been following a long thread on RCgroup most of the good stuff is from page 140, and on with some good tips. This is a long thread I would start in the middle and move along. One thing most agree on is the nose needs some reinforcing to handle the torque from the motor/prop good tips in there on how to do this and the weak landing gear mount and how to fix this area also.
http://www.rcgroups.com/forums/showthread.php?t=474738
From the reviews by people that are flying this in the thread is they love it for both pattern and 3D depending on the setup.
I am waiting for the motor to come in before I start on this plane. Only thing I have done so far is wash the all the parts down with rubbing alcohol to get the mold release off of them.
Good luck with yours I can't wait to get this in the air myself.
John