Thread: Help on a problem on a build, tail wheel assembly
View Single Post
Old 11-03-2011, 10:43 PM   #6
CHELLIE
Super Contributor
 
CHELLIE's Avatar
 
Join Date: Oct 2006
Location: So. Calif
Posts: 15,891
View CHELLIE's Gallery13
Thanked 1,781 Times in 1,704 Posts
Club: Chino Renegades RC Flying Club
Awards Showcase

Ambassador Award  100mph Speed Demon  Outstanding Contributor Award. 
iTrader: (4)
Friends: (281)
Default
install a dowl at the bottom of the rudder so it sticks out about 3/8" and about 1" above the bottom, use a rubber band or o ring from one side to the other with the spring wire on the bottom of the rudder and the rubber band securing the spring wire to the rudder. hope that helps, Chellie
Do not Judge, or you too will be Judged. For in the same way you Judge others, you will be Judged, and with the same measure you use, it will be measured to You.
CHELLIE is offline  
  Reply With Quote
 
Page generated in 0.12806 seconds with 17 queries