[kelleysislander]

Hi Eric,

I was researching "Walkera 2702 set up" and came across this post...

I have tried to decide exactly how this should be set up from the beginning through the calibration steps because I have read conflicting advice...

One fellow says initially set the SWATS AIL/ELE to 80/80 and set the PIT to 40 (half of the AIL or ELE value) because you must do that to get the cyclic pitch correct; the sheet from Wow says set to 70% / 70% / 70% for all three and set up as normal.

How did you go about setting up yours from the initial settings for the mechanical setup to the swash and rudder calibrations? Did you change any of the SWAATS values after the initial mechanical setup?

Thanks,

Bill