That worked put real well, now for the tail!
OK, so the tail servo moves WAAAAAAAAY too far in either direction after setting the RX limits. To set the tail I flipped the switch to "Tail Set" and set the RX travel left and right, pressed the button, etc.
So I think the next thing is to set the Travel of the tail but when I limit the travel to like 25% left and 25% right which is what I need to avoid binding, the tail servo moves real slowly like I have lost the snappy reaction when I had full throw. It seems to get a bit better when I set the rate from HH to Rate Mode.
Any suggestions here for setting up the tail so that the linkage doesn't bind and pop off?
Should I be pushing the stick all the way before setting the throw by pressing the button, or should I be watching the tail pitch slider and pressing the set button when it gets to the end before binding? If I do that it only takes about 1/4" of push on the stick to get the slider to bottom out as the slider keeps moving after I stop moving the stick
Thanks,
Bill
|