Best PSU for Power Lab 8 ?? Hello Everyone I am English but have lived in Norway for 10 years + I married a Viking who looks after me very well..as my health is poor.I am diving in at the deep end with Rc heli`s and being a bit uncoventional
I was told by some very experienced Rc heli Pilots that just because
600 Logo`s & SAB are for the seriouse 3D flyers..there is no reason if you like the look and the spec you to can not fly a tamed down version of the above,with the right set up e.t.c.also the RX can be set up to help you as well so go for it..
I am 99% convinced that when I do eventually end up flying RC Heli.
hopefully a
LOGO 600SE with
DJI.I will go for the powerlab 6 would this be a good and sensible choice?most folk seem to think it would be ideal.
if so what
PSU is considered the best to partner it?
must add I will only ever be flying the
ONE Rc heli (for good rational reasons) so everything must be geared to the one Heli.I have read lots of threads and posts regarding Charger PSU matching so forgive me for yet again asking a question which as being asked many times before..
and because I am only ever going to fly(fingers crossed) the one heli then it should have the best of everything,from batteries to servos and everything in between.
I do not wish to bore you guys to much but for reasons medical there will not be any thought of (
3D or aerobatics?) again logical reasons for this to.
I am trying to achieve something here which if sucsessful will be more wonderful than I could express..and my learning curve as to be faster than would be normally advised?
therfore I would be more than happy to be able to hover at all positions..and do circuits...with something like the
Lego 600se & similar heli`s .
so really it is
charger/Balancer & PSU choice advice I need
many thanks in advance
Steve