The manual says 72 mm = 2.83465 inches = close to 2 and 7/8s.
2 and 5/8ths = 2.625 inches = close to 67 mm
Anyone flying one of these? If yes, what are you using?
edit: after thinking about it 5 mil forward might be a good place to start.
Guys ,
Give me your input. I hung plane upside down on my CG DIY checker.
Actual CG, with nose bit down is between manual's suggested point and 25% (from front chord edge of wing)....Actual cg (denoted by A in pic) is more close to manual's suggested point though. Plane nose pointed to right in pic.
Is this ok? For maiden?
See pic....thx
-- Kris