Radio installation ... thought some might like to see this .. I know I always like to see where people put their gear - helps me sort my model then.
Note that as I don't have a separate elevator servo sitting at the back - I will link ailerons and elevators on single servo each side ... I save tail weight.
Layout is :
Rx forward (FrSky 7ch)
Next bay back is LiPo, on this is a 3S 800 20C of 48grams
Then the ESC sits in the V of the fuselage sides inside the duct area.
The two servos are TG9e servos let into fuselage sides and then will have dual rods each to serve elevator and ailerons ...
The motor wires are extended with solid core copper wire ...
With this and final parts in place - she balances spot on ...
Nigel