Most of these gear would rotate if allowed, but either have a set screw or through-screw to hold it in place. The ones for steering or 90 degree rotating ones instead have a c-clip on top so they don't fall out, and a collar or the steering bracket holding them from the bottom, so they don't go up into it any more.
Hi
I find it extremely difficult to attach a small c-clip in the top of the wheel assembly .
Since the nose gear is attached to the arm as well the odds if this falling out is less right ?
Is there an other alternative other than c-clip..? Can I put a tiny drop of ca or silicone where c-Clip would go ?
Pls advice.thanks a lot
thx...Kris
