View Single Post
Old 11-28-2012, 12:26 PM   #13
baz49exe
Super Contributor
 
baz49exe's Avatar
 
Join Date: Jun 2008
Location: Devon. England
Posts: 1,101
View baz49exe's Gallery15
Thanked 135 Times in 130 Posts
Club: East Devon Radio Control Club
Awards Showcase

Outstanding Contributor Award  Scratchbuilders Award 
iTrader: (0)
Friends: (15)
Default

Added the 10mm square stick mount today and used the same material for the cowl supports. Three servo screws in the ends of the supports will hold the cowl in place.
The motor fits snugly in the spinner section of the cowl with plenty of room to mount the ESC behind ( thank goodness) and a large air flow duct at the lower rear of the housing to provide plenty of cooling for both.


Attached Thumbnails
Click image for larger version

Name:	28-11-12 002s.jpg
Views:	110
Size:	475.8 KB
ID:	164495   Click image for larger version

Name:	28-11-12 003s.jpg
Views:	122
Size:	531.8 KB
ID:	164496  
baz49exe is offline  
  Reply With Quote
 
Page generated in 0.17005 seconds with 20 queries