View Single Post
Old 12-23-2013, 04:42 AM   #1
bossman10728
New Member
 
Join Date: Sep 2013
Posts: 7
Thanked 0 Times in 0 Posts
iTrader: (0)
Friends: (0)
Default Electric Top Flite Giant Corsair

I have the Corsair kit in the process of being built and had run into some questions. It is supposed to end up weighing between 24 and 26 pounds. This is what I have planned on using for all of my electronics:
-Rimfire 65cc (will probably use the recommended prop)
-Castle Creations Pheonix Edge 160A HVF
-X2 6s 8000mah lipo in series
-X8 HD-1501MG servos (Troy Built Models)
-Spektrum AR6210 receiver

I am fairly new to the hobby and I am still learning so any help will be greatly appreciated.

My first question is basically...will this work? If not, what do I need to change? My second question is...with these servos and receiver, will a brown out occur? I've heard about servo voltage boosters but I am unsure if that will help this potential problem. I just want to take the necessary precautions to make sure I will not loose this plane due to an electrical problem. Again, thank you for any possible help.
bossman10728 is offline  
  Reply With Quote
 
Page generated in 0.10708 seconds with 17 queries