View Single Post
Old 12-25-2013, 08:33 PM   #2
CHELLIE
Super Contributor
 
CHELLIE's Avatar
 
Join Date: Oct 2006
Location: Hesperia, So. Calif
Posts: 17,980
View CHELLIE's Gallery13
Thanked 2,072 Times in 1,983 Posts
Club: Chino Renegades RC Flying Club
Awards Showcase

Scratchbuilders Award  Scratchbuilders Award  Ambassador Award  100mph Speed Demon 
iTrader: (4)
Friends: (304)
Default

Hi Bob set the CG to 25% back from the front leading edge, forget what the manual says, they are always off, 25% back is a very safe place to start at, check the wings incident too, i like a 0 - 0 incident in my planes, if thats ok, add a little down thrust to the motor by shimming the motor, with the motor at the rear, the tail end of the motor should be pointing down a tad, about 2 to 3 degrees should be fine, try those recommendations one at a time, hope that helps, Chellie

I may be getting Older, But I Refuse to grow Up I am Having to much Fun to Grow Up LOL
CHELLIE is offline  
  Reply With Quote
 
Page generated in 0.08871 seconds with 17 queries