View Single Post
Old 02-05-2014, 06:00 PM   #1
Mark Wood
Owner: LipoSack.com
 
Mark Wood's Avatar
 
Join Date: Oct 2005
Location: Bear Valley Springs, Ca.
Posts: 116
Thanked 9 Times in 8 Posts
Club: Bear Valley Modelers
Send a message via Yahoo to Mark Wood
Awards Showcase

100mph Speed Demon 
iTrader: (0)
Friends: (1)
Lightbulb Important LipoSack modification

Folks:

You have spoken and we have listened (again).

After we attended the AMA Expo and listening to various suggestions, one we decided to immediately implement solves a nagging issue with our charge bags.
The question heard was (and has been for a while) is "How do I get to those darned short balance leads?"

The issue quite honestly hasn't been a problem for me personally since I use Blinky balancers and I'm very "hands on" during charging but for the majority of users this has been a problem so we solved it in our typical, simple manner. I apologize since this should have been done years ago.

On all of our charging bags there is now a reinforced 1" port at the bottom corner of the bag that allows the user to thread the charging and balance leads easily out of the bag to access those short leads. This alleviates two issues.
1) As noted, the end users can now access their balance leads without having to resort to balance lead extensions which can effect the balancing circuit due to increased resistance.
2) It "encourages" placement of the battery at the bottom of the bag where the system is most effective.

Thanks to those that continue to give us input on our products. It's because of you that we continue to lead in quality and product innovation!

Now available at our webstore! http://liposack.com/store.htm

mw (Mr. LipoSack.com)


Attached Thumbnails
Click image for larger version

Name:	LipoSack lead mod.jpg
Views:	57
Size:	73.2 KB
ID:	173277

Mark Wood is offline  
  Reply With Quote
 
Page generated in 0.13334 seconds with 19 queries