Thread: Navaho Missile
View Single Post
Old 02-18-2014, 06:31 AM   #2
CHELLIE
Super Contributor
 
CHELLIE's Avatar
 
Join Date: Oct 2006
Location: Hesperia, So. Calif
Posts: 17,994
View CHELLIE's Gallery13
Thanked 2,077 Times in 1,987 Posts
Club: Chino Renegades RC Flying Club
Awards Showcase

Scratchbuilders Award  Scratchbuilders Award  Ambassador Award  100mph Speed Demon 
iTrader: (4)
Friends: (304)
Default

Neet project If You can fit 35mm EDF in there that should more than double your thrust, the flying wing has a nice flat lifting body on the bottom plus the wings, it should fly quite well, I would build a profile foam Chuck Glider model to get the cg correct and you might be able to take off with the rocket and edfs at the same time, elevons on the main wing should be all that you need, make them wide, 2 - 9 gram HXT servos should work well mounted flush in the fuselage, I Like it Take care and have fun, Chellie

with the 35mm edfs you will need to use a 20 amp esc each and at least a 2 cell 1000mah lipo 35C each. as they pull 20 amps WOT, you will also need to use a UBEC at least 3 amps so you dont go into a receiver brown out. edfs use a lot of Battery Juice

6 oz thrust each edf , OD. 37mm, total thrust 12 oz
http://www.hobbyking.com/hobbyking/s...Assembled.html

2.3 oz thrust each edf , OD. 29mm, total thrust 4.6 oz
http://www.hobbyking.com/hobbyking/s...assembled.html

I may be getting Older, But I Refuse to grow Up I am Having to much Fun to Grow Up LOL
CHELLIE is offline  
  Reply With Quote
 
Page generated in 0.08525 seconds with 17 queries