View Single Post
Old 03-02-2014, 07:19 AM   #2
CHELLIE
Super Contributor
 
CHELLIE's Avatar
 
Join Date: Oct 2006
Location: Hesperia, So. Calif
Posts: 18,732
View CHELLIE's Gallery13
Thanked 2,190 Times in 2,096 Posts
Club: Chino Renegades RC Flying Club
Awards Showcase

Scratchbuilders Award  Scratchbuilders Award  Ambassador Award  100mph Speed Demon 
iTrader: (4)
Friends: (317)
Default

Originally Posted by DavidR8 View Post
I have a Mikey's RC FPV on my shop table right now. I built it using Elmer's foamboard from Michaels. From what I've read it's heavier than Dollartree board.

Today I picked up 8 sheets from Dollartree. They are also Elmer's brand but feels significantly lighter (also less substantial) than the Michael's board.

I've attached a shot of the label from the stuff I picked up today. Is it what everyone else is using?
Hi I have used that board too, they are all just about the same, Remove the paper from just one side, and the board will still be strong, but lighter, Hope that helps, Chellie

I may be getting Older, But I Refuse to grow Up I am Having to much Fun to Grow Up LOL
CHELLIE is offline  
  Reply With Quote
 
Page generated in 0.09187 seconds with 17 queries