View Single Post
Old 04-30-2014, 04:21 AM   #9
Warbird Fanatic
thepiper92's Avatar
Join Date: Nov 2013
Location: Winnipeg, Canada
Posts: 1,513
Thanked 42 Times in 41 Posts
iTrader: (0)
Friends: (6)

What I do is hold the connector in a pair of pliers with a elastic wrapper around the plier handles. That leaves both hands free. I slip the shrinks around the wires, drip solder is the xt60 holes and then heat it up really quick and push the wires in. Then just take a lighter to the shrink tubes. It helps to have a strong soldering iron, as you can heat up, and put the wire in before the solder solidifies, rather than needing to keep heat on the area.
thepiper92 is offline  
  Reply With Quote
Page generated in 0.04021 seconds with 17 queries