Thread: Hinge tape....
View Single Post
Old 06-26-2014, 11:46 PM   #1
time bandit
Member
 
time bandit's Avatar
 
Join Date: Mar 2014
Location: B'ham, Alabama
Posts: 228
Thanked 4 Times in 3 Posts
iTrader: (0)
Friends: (12)
Default Hinge tape....

I'm using hinge tape on my EVA. How much of a gap should I have between the control surfaces? I laid the horz. stab and elevator flat on my table and carefully put the tape across the hinge line leaving about 1/16th of an inch gap. The elevator would not deflect down much. Am I going about this wrong? I haven't put any tape on the bottom side yet. I did bevel the trailing edge of the horz. stab.

What was I thinking?
time bandit is offline  
  Reply With Quote
 
Page generated in 0.11513 seconds with 17 queries