View Single Post
Old 08-17-2014, 11:51 AM   #1
solentlife
Super Contributor
 
solentlife's Avatar
 
Join Date: Oct 2010
Location: Ex UK Brit now in Latvia west coast - Ventspils
Posts: 6,209
View solentlife's Gallery47
Thanked 266 Times in 263 Posts
Club: Founder Member Ventspils RC Club. Ex Waltham Chase and Meon Valley Soaring.
Awards Showcase

Scratchbuilders Award  Scratchbuilders Award  Outstanding Contributor Award  125mph Speed Demon 
iTrader: (0)
Friends: (15)
Default Enlarging Laser Cutter work area ?

Enlarging Laser cutter work-area ?
I have the 20 x 30cm 40W typical cheap Chinese job waiting at home for me ... and I wonder if it's possible to enlarge cutting area ... Even if the stepper rail is kept same length, is it possible to mount so an open-ended bed is under where a piece to cut can be fed in stages - so cutting a much larger item than the closed box ?
Can the cutter be fitted to longer rail and bigger box ?
My machine will be fine for formers, ribs etc. - but fuselage sides, wing spars will not be possible unless I can extend ...
Any advice / info would be much appreciated ................
Nigel

222kph PKJ,EDF Concorde, Mini4,Mig3,T45,PKJ twin,ME109,Edge540,Cessna182,Skymaster Biplane,F15,F16,Badius,Ultimate,SE5,Qbee10,450 Heli,V911,J3 Cub Founder 9x forum: http://groups.yahoo.com/group/Flysky_RC_radio/
- Subscribe my Youtube: "solentlifeuk"
solentlife is online now  
  Reply With Quote
 
Page generated in 0.08480 seconds with 17 queries