View Single Post
Old 08-22-2014, 06:03 PM   #1
rotorsport
Member
 
Join Date: Mar 2007
Location: Alberta, Canada
Posts: 21
Thanked 0 Times in 0 Posts
iTrader: (0)
Friends: (0)
Default Hobby People Quad F450 Question

I have read the thread and I have my HP F450 almost complete, motors calibrated ok and all turn

I'm using a DSM2 AR7000 receiver I have the throttle connected to the receiver and the A.E.R. port installed with the single post plugged into the receiver

I have 4 single wires coming off the power board Red Yellow, White, and black I assume these are the ESC signal wires that go to the Super Muti-Rotor Controller I will follow them back to see which is ESC 1,2 and so forth

There is a two pin red and black coming of the power board I'm not sure where it goes the only open port on the Super Milti-Rotor Controller is the S-Bus port, is that where this double pin goes?



Charles


http://www.wattflyer.com/forums/show...t=73716&page=2
rotorsport is offline  
  Reply With Quote
 
Page generated in 0.08655 seconds with 17 queries