I'm looking into this plane pretty close. I am interested in tinkering with 3D and I have seen the Visionaire and it was impressive but for some reason I kinda like the Artizan. Just don't know if this plane will help me to learn some 3D moves or not or do I dare say do you think thisar is a good beginner 3D planes? If you own one love to read your thoughts on it
Happy flying may your crashes be limited and if they are not limited let them be cool.
Fishbonez, I'm sure this plane is everything it's advertised to be. Probably not a 3-D trainer though. There are several Tech-One profiles that would serve you better. My favorite is the SU-31, 1000mm. Very affordable, durable and acrobatic. Dial your throws back if it's too quick for you. Or fly it slower and use bursts of throttle to make those large control surfaces work for you. Oh, and they look cool too.
I flew my Artizan for the first time today and found it to be very out of trim, especially the elevator. I had to put in all of the available up elevator trim and it still wasn't enough. Is your Artizan using the AR615 Rx?
Life's journey is not to arrive at the grave in a well preserved body,
but rather to skid in sideways totally worn out shouting, Holy Crap... what a ride.
After 20 flights I am convinced this is the heir apparent to the T-28 as a low wing aileron trainer. She is impervious to wind and lands the easiest of any tail dragger I have flown. I just got a VisionAire and plan to do a comparison of the two. But it's true, the Artizan is NOT a 3D plane although it can do some nice aerobatics. Flew her today with my FZ Acro-Wot. The Artizan is easier to fly, and just as aerobatic.
These things are usually pretty close. Did you check for balance? Are all of the components in their correct locations? Hinges installed correctly and glued securely? Motor installed securely. So many things could cause this, wing mounted securely in its saddle. Does the elevator appear to be out of alignment? Does it have the same trim issues flying inverted? How about when power is off and gliding?
My BNF Artizan is using the AR635 AS3X receiver. As far as the elevator goes, you need to MECHANICALLY trim the elevator out before you fly it; looks can be deceptive because the HStab looks to be angled downward. If it is diving, and you are using a lot of up trim, add it gradually on the ground until she flies straight and level at just over half throttle. It may take a bit of trial and error, but once dialed in, she flies like a dream.
I just picked up the Artizan and am setting it up tonight. The manual says to setup dual rates of 100% and 70% throws but does not mention expo. I have been using some expo on my previous models and am wondering if the omission of any mention of expo was deliberate. So, Expo yes or Expo no?