A lightweight and agile high performance 3D plane that will push your skills to the limits!
Reinforced with CF, and complete with option fins for precision tracking, this plane is designed for ultimate 3D and beyond!
This kit includes a 3D ready motor, prop saver and propeller. You just need 2 5g and 2 9g servos, a 12~15A ESC, 800mAh battery and receiver.
Construction time is around 3hrs.
Battery : 2S~3S 800mah 15C I went with a 7.4 volt 2cell 25-350 pack (25-30C)
Servo : 2 x 5g , 2 x 9g I went with 4 5 gram servo
ESC : 12A Im only using a 10 amp brushless ESC
Your own TX & RX
I was wondering what 5g servo's you used?
I am looking at getting a similar setup (2s 7.4 volt lipo)
but a lot of the 5g servos i see are rated 4-6 volts,
just wondering if they also go ok on 7.4v.
Good flying. o