electric smoke system???

[dmmalish]

anybody tried these i got some getting ready to try them this week will post photos if it works just wanted to know what to expect if anybody has tried them

RCSmoke.com (A Member of the Regin HVAC Family)

[wjmoore]

How did these work for you? I am looking for some way to add smoke to my park flyer planes.

Without a muffler for heat, the smoke liquid is out of the question. Or is it?

All input is highly appreciated.

[paranoia]

hobbylobby has some too, i think you just light them and away they go....

[TeslaWinger]

I got several colors of the HL smokers. Put it on the bottom of a Lil Rascal (hanging down and aft) and burned a hole in the Monokote and scorched the balsa a bit. Easily fixed but disturbing at the time! The Purple is awesome! Dense, colorful and shows up whether blue or grey sky!

[dmmalish]

Originally Posted by wjmoore

How did these work for you? I am looking for some way to add smoke to my park flyer planes.

Without a muffler for heat, the smoke liquid is out of the question. Or is it?

All input is highly appreciated.

i tried them last week i did not use a fuse just tried to light them did not work will try again using the fuse will post results when able so far expensive for what you get i think

[dmmalish]

this photo was taken last wednesday night like i said before not sure i will buy again they tend to flame up i damaged my covering on this flight but they do look cool if you can come up with a better way to mount them that is my report

[dmmalish]

here it is

[Spencer J]

Hobby-Lobby sells smoke bombs that you can slap on your plane, all I remember is that they are $$$$............

[Barry Townsend]

Hi I am working on an electric smoke system that will give similar results to a conventional gas/ic smoke system. I have tested a system that will run off a 2s 1800 mAh lipo it did give off a great smoke stream using normal smoke oil. I need to develop the unit into a convenient size package that will be suitable for mid to large size electric models. Stay tuned I will have this system up and running within the next few months.

[CNY_Dave]

Don't forget an automatic voltage cutoff...

[dmmalish]

keep us posted!!!!!!!!!

[CHELLIE]

Originally Posted by Barry Townsend

Hi I am working on an electric smoke system that will give similar results to a conventional gas/ic smoke system. I have tested a system that will run off a 2s 1800 mAh lipo it did give off a great smoke stream using normal smoke oil. I need to develop the unit into a convenient size package that will be suitable for mid to large size electric models. Stay tuned I will have this system up and running within the next few months.

good luck to you I have tried to make a e powered smoke system with very little luck, a ballist resistor surounded with fiberglass insulation soaked with ATF, it worked but did not put out a lot of smoke, and it could catch fire Keep us informed. Chellie

[pattern14]

I used the RCsmoke system for the last 12 months and they work great. I have a remote ignition system set off on the retracts channel to simulate being hit by flak Can't say too much more, as I am on my lunch break, but I'll get back to you in the next day or so

[Barry Townsend]

Check it out any questions just ask. Barry

http://www.facebook.com/photo.php?v=...type=3&theater

[Barry Townsend]

Check it out, no pump, needle valve, pressure feed or shut off valve required it draws the required amount of fuel through 2 burners. I have just set up using 3 burners it does give more smoke but does run a bit hotter runs of 11.1 lipo from 1000mAh up.
Demo is the 2 burner using an 11.1v 2200mAh will run continuously until the battery loses power or the fuel runs out, I did run this unit for at least 15 mins the case only got warm and there were no issues.
Will be operated using a mini servo on a micro switch to turn on and off.

http://www.facebook.com/photo.php?v=...type=3&theater

[CNY_Dave]

Pretty cool.

Do you think when on a plane it will need a fan?
A smoother airflow will leave a denser (but thinner) column of smoke.

Maybe a venturi sticking out the side of the fuse.

[Barry Townsend]

The first tests were with no fan and the unit did catch on fire? (ground run) the issue is the heat with no air flow. I will set it up on a model and try both as I am aware of natural air flow and obviously...you would not run it on the ground but you know what people are like?

Thanks for your input I am open to any suggestions. Cheers Barry

[CNY_Dave]

A good test of drawing the air into a tube or venturi might be to place the unit at the front end of a clear plastic pipe, and the fan down at the other end.

Temperature regulation might be necessary, maybe only a simple temp snap-switch like they use to protect electric heaters would do it.

Like these, many appliances use the ones that are about the size of a thumbnail.