Just received 2 new 3S 2100 mah 25C batteries.
I am a bit new at this but something appears wrong. The balance plug is a 5 pin with 4 wires, rater than 4 pin with 4 wires. What is going on?
I would try it in my charger but the batteries did not come terminated with the high current plug I use. Need to get some EC3 connectors. Something tells me my charger will not like the balance plug.
FWIW I have an ICharger 1010B
OK I got it fixed and it was Super Easy took less than 2 minutes to fix. All you need is a small jewelers screw drive or Exacto Knife, flat surface, and good light.
The Poly quest 3S Balance plug comes with a 5 position plug and will fit into a standard 4S JST-XH socket. On my charger board it will take anything from 2S up to 10S. On th ePoly Quest connector the wires are on position 5, 3, 2, and 1. They skip 4. At first I thought to move the wire from 5 to 4 which did not work. My charger cane up ERROR. That is when I seen the problem, I made the wrong assumption.
So here it is Leave the Black Wire in pos 5 where it is at. Move all the other over 1 position so you end up with wires in position 5, 4, 3, and 2. Position one will be blank..,
That's it guys, it could not be easier.
Just be careful. Do not press too hard on the Barb on the pin connector or else you will spring it. Easy to fix if you have really good eyes by prying it back up. MOVE ONLY ONE WIRE AT A TIME
or else you let the magic smoke out and and might start a fire.