My Lanyu Cessna 182 TW-747 III

[DCDetector]

The extra battery I use is a Dynam 2200mA h 11.1V 20C

Yellow Motor wire to ESC red wire
Black motor wire to black ESC wire
Red motor wire to ESC blue wire

[Perker]

Originally Posted by xptential

I got it all together with two problems...The flaps go up not down...even tried flipping the 5th switch position...and when i shut it of the motor started...HELP !!!

I am having the same problem! Did you ever get the problem resolved? If so, how. Thanks

[Perker]

Originally Posted by DCDetector

The extra battery I use is a Dynam 2200mA h 11.1V 20C

Yellow Motor wire to ESC red wire
Black motor wire to black ESC wire
Red motor wire to ESC blue wire

Thank you.

I just discovered that my flaps are going UP (not down). The servo arm rotates back toward the trailing edge, thus pushing the flaps up. Both servos are doing it. I tried different switch positions on the transmitter....no luck.
I contacted the seller (GENERALHOBBY), no luck there. Another member (XPTENTIAL) had the same problem. Is it possible the wrong servos are installed or? ANY IDEAS...... THANKS AGAIN

[upuprcflyn]

Hey all I finally installed the links to the flaps and servos on my cessna 182 Skylane 747 III.

When I power on the radio then connect the battery both flaps are in line with the wings but when i power off the flaps rest in the down position. Is this normal or are the servos pre installed backwards on the flaps?

[upuprcflyn]

Hey Preker

Join the club got mine from the same place problems every since i got it LED lights worked aft initial set up and never came back on. called and emailed them many times not much help with problem, so i ask them to send me another LED module thinking that may b the problem, instead they sent me a new battery until they can send me the LED module.

New batt did not do any good plus one of the cells were well below the other two. still waiting for the module, got the plane xmas 2012 have not flown it yet due to frustration making everything work, nice fantastic plane but i think we got the lemons in the batch

[upuprcflyn]

One more thing my flaps did the same as yours they went up, so to get them to work I connected the rods to the horns with the flaps in the down position.

I think this is why when i power up the go in the even position and when i power off the go into the down position. this cant b wright but its the only way to stop them from going up