Blade CX battery issue

[Lone Beagle]

Not sure if it is the battery or the receiver. When I plug the battery in the LED blinks once and that is it. The battery is fully charged. I have tried it with the Tx on and off. Anybody have any suggestions?

THanks

[Heli Jim]

Could be a lot of things.

Which CX do you have? there's more than one.

How old is the battery? Did you ever over discharge it?

Have you crashed the heli:? There are a lot of different reasons
that you are seeing the problems with your CX.

The easiest to check would be to use a brand new battery
and see if the problem goes away. If it does, then it was
the battery that was the problem They do wear out over time
and I suspect that's your problem.

[Lone Beagle]

It is a Scout CX.
The battery is only a few weeks old and has only been in a few flying sessions.
I will try another one.

Thanks

[Lone Beagle]

Ok it is a Scout CX and it is not the battery. I switched batteries and the helicopter did the same. One blink of the LED then nothing. The batteries work fine in a small airplane I have.

Any suggestions?

Thanks,
John