binding process foiled by instant solid green on tx moduel?any suggestions.

[stuart]

i had an issue but now its resolved...lol...thankfully i have to rebind every rx to the new tx assan module. post # 2 was the solution to getting the led light from green to fast blinking red during rebinding rx's.

[stuart]

I got this tibit of info to try...all transmitter settings need to be set for 100%.....iv adjusted every plane memories with epa's around 90% movement. i do this so servos don't bind. and then all my duel rate never use 100% throw as control horn settings get the same results.

now i'll try setting a model memory to all full rates,jiggle the #2 channel stick and see if i can get the module to enter bind mode and try again friday.


already rebound several rx's that were easy to get at...the rest are buried under wings and such...still i'm thrilled for the easy answer i got at the hk forum.


should have all planes rebound this weekend!!!!!! man,i gotta get some flying in!