Dx6i aileron-rudder mix? - WattFlyer RC Electric Flight Forums

xmech2k · 04-28-2011, 05:32 AM

I found this thread, http://www.wattflyer.com/forums/showthread.php?t=59643 , which talked about some control mixing with a Dx6i, but not much detail at all. So it must be possible, but I can't find it in my manual. Could someone just point me to the right page? All I can find is the tail mixing, for elevons, v-tail, or seperate aileron servos. I was thinking about mixing some rudder with my ailerons.

slipstick · 04-28-2011, 09:16 AM

You need to use one of the programmable mixers (Mix 1 / Mix 2). See P70 in the manual.

Steve

xmech2k · 04-28-2011, 12:32 PM

OK, thanks. I'll check it out.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Dx6i mixing question	bamaerker	Beginners	18	02-23-2012 04:21 AM
PZ F4u corsair-lost contact...hard landing, broke aileron servo arm-need replacement	tehlump	Warbird Electrics	12	03-07-2011 06:40 PM
Aileron Trainer - Really?	rcers	Beginners	18	02-12-2011 04:01 AM
Park T28D Trojan and DX6I Question	gmar777	Beginners	3	02-03-2011 06:06 PM
Bank and Yank flyers... I know your out there	SmoothCruizer	Beginners	62	01-16-2011 07:58 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thank you for your support (hide ads)