Thunder Tiger Japanese ZERO

[guapoman2000]

Hi Guys!

Since my goals are to setup my new Thunder Tiger as a typical Park Flyer and most especially fly it scale like even though it came with a very capable Brushless Outrunner motor, I decided to open the thread here as it will be a Park Flyer and it will fly in a Park and of course my RC Club when the grass field be recently cut!!!

Nothing to be disappointed here of my unpacking of my brand new Thunder Tiger Japanese ZERO! A typical packing job by Thunder Tiger and Tower as the model came in a larger box and the inner box from Thunder Tiger was SEALED with their special round seal marker adhesive decal.

The model was expertly packaged and nothing, I mean NOTHING was damaged, nicked, dented nor molested in any way!

The Paint job and density of the FOAM was EXCELLENT for a EPS foam model and super light. I did not see any voids, low spots nor bubbles of any kind.

Again the paint job is 1st Rate!!!

I have several pictures and the last few are with the GWS Japanese ZERO product.

[captdave221]

I had one of these in the air for about 10 seconds before the Kamakazi pilot crashed it into the side of my brick house. Total loss except for the motor. Don't think I'll buy another one.

[Monterey10]

I have one in the box, so I'm watching your thread. From what I've read, they have a particularly vicious torque roll on hand launch.

[guapoman2000]

Originally Posted by Monterey10

I have one in the box, so I'm watching your thread. From what I've read, they have a particularly vicious torque roll on hand launch.

I will try and not to put too much Throttle on Take-Off to avoid the vicious torque roll. Additionally, I will be placing some additional Right Thrust and Down Thrust to off-set any high RPM P-Factor on take-off.

Carlos