hi im new to rc helicopters and i bought a u180 fly wolf as a beginner rc heli, at first it was working fine then i crashed it a couple of times the blades are all in good condition so when i try to fly it it just spins counter clockwise and wont fly (the blades are moving too) please help please and thankyou
Also the hits: i was flying my rc heli almost hit my roof about 6-7 feet high and i let it fall instead of hitting the roof Hit2:my rc was on the floor and my genious little brother decided the acclerate into my tv while it was still on the floor
Its Hard to say What the Problem is with out seeing the heli, can you post a video, one blade should be spinning CCW and the other CW, they should both be spinning at the same speed, the blades could be out of adjustment, the motor to gear could be to tight or to loose, one of the motors could not be working, the main shaft could be bent and binding, just to hard to tell what the problem is with out seeing it, take care, Chellie
The Videos Below will give you a General Idea of what to look for.
I may be getting Older, But I Refuse to grow Up I am Having to much Fun to Grow Up LOL
This issue is the "Drive Gear Unit" It is the small gear just above the motors which is attached to the large gear. You will have seen several posts indicating that sometimes this gear shifts and does not engage the larger gear. In my case I looked and say that it was indeed trying to engage the larger gear, however the gear is stripped.
Hopefully on the older models there will be parts available for you to replace. The copter cannot work until the part is replaced.