View Full Version : Motor Rewinding - Rimfires and a C10 micro

03-16-2017, 08:49 PM
I've got a couple of brushless motors that I need to rewind. I've had pretty good success at rewinding some of my motors but I've got a couple that seem to be a mystery as far as wire size and turns, even counting the turns and using my digital calipers to determine wire gauge during disassembly. I've listed the motors in question below;

Motor Wire Gauge #of Turns

Rimfire 300
Rimfire 180
HK/Nitro Planes C10

I don't really have a need to make them hotter or change the KV, I would just like to rewind them back to factory specs. Any information on the correct wire gauge and number of turns for the motors listed above is GREATLY appreciated.