Go Back  WattFlyer RC Electric Flight Forums - Discuss radio control eflight > DetroitHawk
Reload this Page >

Conversation Between DetroitHawk and jaycook777

Conversation Between DetroitHawk and jaycook777
Showing Visitor Messages 1 to 1 of 1
  1. 01-11-2010 08:10 AM
    Hi,

    I was looking at a post you made with two different outrunner motors pictured. One has the shaft sticking out the back. I had a Turnigy motor with the same setup. Shaft sticking out the back and a bolt on prop adapter on the front.

    My Corsair's stock Parkzone motor had the shaft sticking out the front and a prop adapter that set screwed onto the shaft.

    Could you give me your opinion on why they have the shaft sticking out the rear, and the difference between using a prop adapter that bolts on compared to the set screw on the shaft type.

    Thanks for your time,
    Jay Cook

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.

Page generated in 0.04599 seconds with 13 queries