WattFlyer RC Electric Flight Forums - Discuss radio control eflight - View Profile: jrb

jrb jrb is offline

Member

Visitor Messages

Showing Visitor Messages 1 to 2 of 2
  1. jrb
    08-05-2008 07:00 PM
    jrb
    Been traveling; sorry for not seing this earlier Peter.

    Good question for post; lost will learn from the responses.

    Depends a bit your battery connector.

    With Deans you need a harness (make or buy).

    With Sermos/Aderson Power Pole you can split to red and black from one pack and make a series connection.

    BOL!

    Jim
  2. PetesCub
    07-30-2008 07:17 PM
    Hi JRB,

    I noticed you have a 1/5 Cub. I have completed a 1/5 Anniversary SIG Cub and I'm going electric. I have a 4120/20 AXI brushless and a JETI 70 Opto plus ESC (No BEC). I have ordered 2 Zippy 4800Mah 3S 20C Lipo's which are on the way. My question to you is this. What will I need to connect these batteries in series, and then to the ESC? I'd like also to add a BEC if possible. I was hoping you may have some advice about how to best go about setting this up, be Dean's Ultr or bullets etc. Any advice would be muh appreciated.

    Best,
    Peter

Statistics

Total Posts
Visitor Messages
General Information
  • Last Activity: 12-03-2008 03:38 PM
  • Join Date: 07-29-2005
  • Referrals: 0

iTrader

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.

Page generated in 0.04666 seconds with 23 queries