WattFlyer RC Electric Flight Forums - Discuss radio control eflight - View Profile: DetroitHawk

DetroitHawk DetroitHawk is offline

Super Awesome

About Me

Statistics

Total Posts
Visitor Messages
General Information
  • Last Activity: 10-14-2013 03:33 PM
  • Join Date: 05-01-2006
  • Referrals: 0

Visitor Messages

Showing Visitor Messages 1 to 2 of 2
  1. 01-11-2010 07:10 AM
    Hi,

    I was looking at a post you made with two different outrunner motors pictured. One has the shaft sticking out the back. I had a Turnigy motor with the same setup. Shaft sticking out the back and a bolt on prop adapter on the front.

    My Corsair's stock Parkzone motor had the shaft sticking out the front and a prop adapter that set screwed onto the shaft.

    Could you give me your opinion on why they have the shaft sticking out the rear, and the difference between using a prop adapter that bolts on compared to the set screw on the shaft type.

    Thanks for your time,
    Jay Cook
  2. 09-03-2008 11:02 PM
    hi hawk, i STILL haven't flown my alpha spit!! been too FXXXkin' windy all summer, and when it hasn't been i've flown the zero, hope you're well, S~

iTrader

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.

Page generated in 0.11892 seconds with 24 queries