WattFlyer RC Electric Flight Forums - Discuss radio control eflight

WattFlyer RC Electric Flight Forums - Discuss radio control eflight (https://www.wattflyer.com/forums/index.php)
-   New Product Announcements (https://www.wattflyer.com/forums/forumdisplay.php?f=38)
-   -   New PWM Meter & Low Voltage Cutoff Switch (https://www.wattflyer.com/forums/showthread.php?t=79041)

ServoCity 11-30-2017 11:03 PM

New PWM Meter & Low Voltage Cutoff Switch
 
https://www.servocity.com/media/cata...ng4-1500px.jpghttps://www.servocity.com/media/cata...ler-1500px.jpghttps://www.servocity.com/media/cata...ver-1500px.jpg
PWM Meter - $19.99
Need to know what PWM signal your receiver, robot or servo controller is sending? Simply plug in our PWM Meter to see a readout of the PWM signal in microseconds (µsec). If you wish to pass that signal on to your servo or device, just plug into the other set of header row pins.

https://www.servocity.com/media/cata...ang3-600px.jpg
Low Voltage Cutoff Switch - $19.99
It's important to protect your LiPo batteries from being drained below 3V/cell and our Low Voltage Cutoff Switch does just that. This switch has 3 modes; 1S, 2S or 3S and it simply passes the voltage on from the battery to the load (motor controller, ESC, servo controller, light, etc.) until the battery meets the cutoff voltage.

Whether you are powering a microcomputer like a Raspberry Pi, a microcontroller like an Arduino or an RC vehicle, our Low Voltage Cutoff Switch takes away one of the main challenges of working with LiPo batteries.


All times are GMT +1. The time now is 09:16 AM.

Powered by: vBulletin
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.
Copyright © 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.

Page generated in 0.03935 seconds with 7 queries