help! himax and turnigy plush 60a
 

Folks

Have my multiplex mentor ready to go. Connected my Multiplex Himax 3528-1000 brushless outrunner to my Turnigy plush 60a esc, connected my 3200mah 3s 11.1v lipo. Turned on the tx and rx. Esc went through normal startup sequence of beeps. When I apply throttle motor shudders a few grating rotations and then stops. it doesnt sound healthy. like an old engine trying to start in winter. repeated the process a few times to the same results.

the motor spins fine and freely in my hand when i rotate the prop with the power off.

Your help would be greatly appreciated.

zoom

Might start by double checking the solder joints at you bullet connectors. Had something like that on a motor once and when I pulled on one of the wires it came right out of the plug. Resoldered it and no troubles since.

Offtom,

Did just that and it worked a treat. Hope to get flying next weekend. thanks a mil.

zoom

You're more than welcome and good luck flying next weekend.